LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2008 >> R32 >> Repair and Diagnosis >> External Pages >> Different car >> Section 40 (Clutch - 5-Speed Manual Transmission 0A4 (As Of 06.2011)) >> 30 Clutch >> Removal And Installation >> Master Cylinder

Master Cylinder

WARNING: This page is about a different car, the 2009 Volkswagen Rabbit, 2008 Volkswagen Rabbit, 2007 Volkswagen Rabbit, and 2006 Volkswagen Rabbit. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required 

Removing 

-- Remove the mounting bracket. Refer to one of the following:

Rabbit for Model Year (MY) 2006-2009, refer to MOUNTING BRACKET .

Golf from MY 2010, refer to .

-- Disengage the mount from the clutch pedal using the pliers T10005.

Fig 1: Disengaging Master Cylinder Operating Rod Mount Using Pliers T10005
GWWA30-0118Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Place a spacer -A- between the clutch pedal and the jounce bumper and then push the clutch pedal to the spacer.

Fig 2: Disengaging Securing Bracket And Pulling Master Cylinder Out Of Mounting Bracket
GWWA30-0119Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Disengage the master cylinder -B- and remove the master cylinder from the mounting bracket, first in the -direction of arrow 1- and then in the -direction of arrow 2-.

Installing 

-- Install the mount -2- onto the clutch master cylinder actuator rod -1-.

Fig 3: Installing Mount On Master Cylinder Operating Rod
GWWA30-0120Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Place a spacer -A- between the clutch pedal and the jounce bumper and then push the clutch pedal to the spacer.

Fig 4: Engaging Master Cylinder On Mounting Bracket
GWWA30-0121Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install the clutch master cylinder to the mounting bracket, first in the -direction of arrow 1- and then in the -direction of arrow 2-.

-- Push the clutch master cylinder actuator rod -1- in the -direction of the arrow- until the mount -2- clicks into the place in the clutch pedal.

Fig 5: Pressing Master Cylinder Actuator Rod Until Mount Engages Audibly In Clutch Pedal
GWWA30-0122Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install the mounting bracket. Refer to one of the following:

Rabbit for MY 2006-2009, refer to MOUNTING BRACKET .

Golf from MY 2010, refer to .