Shift Lever And Housing, Through 10.06: Notes

WARNING: This page is about a different car, the 2009 Volkswagen Rabbit, 2008 Volkswagen Rabbit, 2007 Volkswagen Rabbit, and 2006 Volkswagen Rabbit. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Lubricate the bearing areas and the sliding surfaces.

Fig 1: Exploded View Of Shift Lever And Shift Housing (Through 10.06), Servicing

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Lock Washer
- Removing and installing, refer to LOCK WASHER, REMOVING AND INSTALLING .
Bushing
Pressure Spring
Bushing
Bolt
- 5 Nm
Cover
Sound Insulation
Bearing Shell
Bearing Shell
Shift Lever Guide
Washer
Gasket
- Between the shift housing and the underbody.
- Self-adhesive.
- Affix to the shift housing.
Shift Lever
Shift Housing
Bushing
Pin
Bushing
Pressure Spring
- Installing, refer to PRESSURE SPRING, INSTALLING .
Selector Bracket
Bolt
- 5 Nm
Gasket
- Always replace.
Base Plate
- Bend the tabs in order to remove.
- Always replace.
Selector Cable
- To the selector bracket.
- Removing and installing, refer to SELECTOR CABLE AND SHIFT CABLE, REMOVING AND INSTALLING .
Shift Cable
- Removing from, and installing to the shift lever guide, refer to SELECTOR CABLE AND SHIFT CABLE, REMOVING AND INSTALLING .
Lock Washer
- Always replace.
Nut
- M8: 25 Nm
- M6: 8 Nm
- Quantity: 4
Bushing
- Fits in one position only
Lock Washer
- Always replace.