Electrical And Electronic Components And Locations

WARNING: This page is about a different car, the 2009 Volkswagen Rabbit, 2008 Volkswagen Rabbit, 2007 Volkswagen Rabbit, and 2006 Volkswagen Rabbit. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Electrical/Electronic Components And Component Locations

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Transmission Control Module -J217-
- The control module sends and receives data from the Data bus.
- Installed location, removing and installing, refer to Fig 2.
- Can be checked in "Guided Fault Finding" using the vehicle diagnostic tester.
Engine Control Module
- The control module sends and receives data from the Data bus.
- Removing and installing, refer to ENGINE CONTROL MODULE WITH ANTI-THEFT IMMOBILIZER , [For engine(s) BGP, BGQ, CBTA, CBUA] ENGINE CONTROL MODULE, WITHOUT ANTI-THEFT PROTECTION , [For engine(s) BPY] Engine Control Module -J623- , or [For engine(s) CCTA] ENGINE CONTROL MODULE -J623-, GTI (2008 THROUGH 2009) .
Multifunction Transmission Range Switch -F125-
- Installed location, refer to Fig 3.
- Can be checked in "Guided Fault Finding" using the vehicle diagnostic tester.
- Removing and installing, refer to Multifunction Transmission Range Switch -F125- .
- Adjusting, refer to Multifunction Transmission Range Switch -F125-, ADJUSTING
Valve Body
- Installed location, refer to Fig 4.
- The components can be checked in "Guided Fault Finding" using the vehicle diagnostic tester.
Sensor Wiring Harness
- With the transmission fluid temperature sensor.
- Installed location, refer to Fig 5.
- Removing and installing, refer to SOLENOID VALVE AND SENSOR WIRING HARNESS .
Transmission Fluid Temperature Sensor -G93-
- Installed location, refer to Fig 5.
- Can be checked in "Guided Fault Finding" using the vehicle diagnostic tester.
Solenoid Valve Wiring Harness
- Installed location, refer to Fig 6.
- Removing and installing, refer to SOLENOID VALVE AND SENSOR WIRING HARNESS .
Automatic Transmission Hydraulic Pressure Sensor 1 -G193-
- Not installed in all transmissions.
- Installed location, refer to Fig 7.
Automatic Transmission Hydraulic Pressure Sensor 2 -G194-
- Not installed in all transmissions.
- Installed location, refer to Fig 7.
Transmission Input Speed Sensor -G182-
- Removing and installing, refer to Transmission Input Speed Sensor -G182- .
- Can be checked in "Guided Fault Finding" using the vehicle diagnostic tester.
Transmission Output Speed Sensor -G195-
- Removing and installing, refer to Transmission Output Speed Sensor -G195- .
- Can be checked in "Guided Fault Finding" using the vehicle diagnostic tester.
Shift Lock Solenoid -N110-
- Installed location: The shift lock solenoid is located in the selector mechanism.
- Can be checked in "Guided Fault Finding" using the vehicle diagnostic tester.
Tiptronic Switch -F189-
- Installed location, refer to Fig 9.
- Can be checked in "Guided Fault Finding" using the vehicle diagnostic tester.
Terminal 50 Power Supply Relay -J682-
- Inside the engine compartment E-box. Refer to the appropriate SYSTEM WIRING DIAGRAMS information.
Diagnostic Connection
- Installed location, refer to Fig 10.
Transmission Range Display -Y6-
- Installed location, refer to Fig 11.
- Removing and installing, refer to Removal and Installation .

Transmission Control Module

Fig 2: Transmission Control Module (TCM) J217

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Installed location: The control module -arrow- is located in the left front wheel housing.

-- The wheel housing liner must be removed for the removal and installation.

Multifunction Transmission Range Switch

Fig 3: Multi-Function Transmission Range (TR) Switch F125

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Installed location: The switch is located on the upper side of transmission.

Valve Body

Fig 4: Valve Body

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Installed location: The valve body is bolted to the underside of the transmission housing and is covered by the transmission fluid pan.

The solenoid valve 1 -N88-, solenoid valve 2 -N89-, solenoid valve 3 -N90-, solenoid valve 4 -N91-, solenoid valve 5 -N92-, solenoid valve 6 -N93-, solenoid valve 9 -N282- and solenoid valve 10 -N283- are secured to the valve body.

Sensor Wiring Harness

Fig 5: Wiring Harness, 8-Pin

Courtesy of VOLKSWAGEN UNITED STATES, INC.

With integrated transmission fluid temperature sensor -arrow-

Solenoid Valve Wiring Harness

Installed location: The wiring harness is secured to the valve body in the transmission.

Fig 6: Wiring Harness, 14-Pin

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Installed location: The wiring harness is secured to the valve body in the transmission.

Automatic Transmission Hydraulic Pressure Sensor 1 and Automatic Transmission Hydraulic Pressure Sensor 2

Fig 7: Automatic Transmission Hydraulic Pressure Sensor 1 G193 And Automatic Transmission Hydraulic Pressure Sensor 2 G194

Courtesy of VOLKSWAGEN UNITED STATES, INC.

These sensors are not installed in all transmissions.

Installed location:

The automatic transmission hydraulic pressure sensor 1 -1- and the automatic transmission hydraulic pressure sensor 2 are installed in the valve body.

Transmission Input Speed Sensor and Transmission Output Speed Sensor

Fig 8: Transmission Input Speed (RPM) Sensor G182 And Output Speed (RPM) Sensor G195