Solenoid Valve And Sensor Wiring Harness

WARNING: This page is about a different car, the 2009 Volkswagen Rabbit, 2008 Volkswagen Rabbit, 2007 Volkswagen Rabbit, and 2006 Volkswagen Rabbit. However, it is still accessible from the selected car via links, so may be relevant.

Removing

-- Drain the transmission fluid. Refer to TRANSMISSION FLUID, DRAINING AND FILLING .

-- Remove the valve body. Refer to VALVE BODY .

-- Disconnect the connectors from the transmission:

-1- transmission sensor terminal

-2- connector for solenoid valves

Fig 1: Identifying 8-Pin G68 and 14-Pin G93 Electrical Harness Connectors

Courtesy of VOLKSWAGEN UNITED STATES, INC.

-- Disconnect the connector housings from the transmission.

-- Disconnect the connector housing together with the wiring harness outward from the transmission housing.

Installing

-- Replace the seals on the connector housings.

-- Carefully guide the wiring harness from the outside into the transmission.

-- Coat the connector housing seals with transmission fluid and then press the connector housing all the way into the transmission.

-- Connect the connector housing, tightening specification, refer to FASTENER TIGHTENING SPECIFICATIONS .

-- Install the valve body. Refer to VALVE BODY .