EVAP System Component Overview
WARNING: This page is about a different variant/trim than selected.
- Fuel Tank
- Vent Line
- Behind the right rear wheel housing liner.
- Vent Line
- On the vehicle floor.
- Vent Line
- To the EVAP canister purge regulator valve 1 -N80- at the intake manifold.
- To remove, press the release button.
- Bolt
- 8 Nm
- Evaporative Emission (EVAP) Canister
- for engine codes BGQ and CBUA.
- Installed location: On the bottom of the spare tire wheel well.
- Removing and installing, refer to EVAP CANISTER .
- EVAP Canister
- For engine codes BGP and CBTA.
- Installed location: On the bottom of the spare tire wheel well.
- Removing and installing, refer to EVAP CANISTER .
- Connecting Pipe
- Pressure side.
- On the vehicle floor.
- Connecting Pipe
- Pressure side
- Behind the right rear wheel housing liner.
- Bolt
- 3 Nm
- Air Filter Housing
- For the leak detection pump.
- Connecting Hose
- Intake side.
- Bracket
- For the leak detection pump.
- Secured inside the right rear wheel housing.
- Bolt
- 2 Nm
- Nut
- 9 Nm
- Leak Detection Pump -V144-
- Installed location: Under the right rear wheel housing liner.
- Removing and installing, refer to Leak Detection Pump -V144- .
- Connector
- Black, 3-pin
- Vacuum Line
- Vehicles through MY 09: from the intake manifold.
- Vehicles from MY 10: from the connection to the vacuum line between the vacuum pump and the brake booster.