Leak Detection Pump -V144-

Removing 

-- Remove the right rear wheel housing liner. Refer to Removal and Installation .

-- Disconnect the vacuum line -2-.

Fig 1: Identifying Leak Detection Pump (LDP) V144 Electrical Harness Connector

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Disconnect the connector -3-.

-- Disconnect the vent line -4- by pressing the release button.

-- Remove the cap nuts -1-.

-- Remove the leak detection pump with the bracket.

Installing 

Installation is performed in the reverse order of removal. When doing this note the following:

• The vent line -4- must engage audibly.
• Make sure the lines are connected securely.

Tightening Specifications