Pedal Cluster Assembly, Overview
WARNING: This page is about a different variant/trim than selected.
1 - Bulkhead
- With support and clutch master cylinder housing
2 - Gasket
- Always replace
3 - Support
- For clutch pedal housing
4 - Bolt
5 - Support
- For accelerator and brake pedal housing
6 - Hex nut, self-locking 25 Nm
- Always replace
7 - Connecting plate
8 - Hex nut, self-locking, 25 Nm
- Always replace
9 - Mounting bushing
10 - Mounting pin
11 - Clutch pedal
- Removing and installing. Refer to Clutch pedal, removing and installing
12 - Bearing bracket
- Removing and installing. Refer to Hydraulic components, assembly overview , item 4
13 - Hex nut, self-locking, 25 Nm
- Always replace
14 - Clutch master cylinder
- Removing and installing. Refer to Clutch master cylinder, removing and installing
15 - Circulation hose
16 - Over-center spring
- Removing and installing. Refer to Over-center spring, removing and installing
17 - Over-center spring seating
- Install in mounting bracket
- To replace, remove and install clutch master cylinder. Refer to Clutch master cylinder, removing and installing
18 - Clutch vacuum vent valve switch -F36-
- When removing and installing switch, push clutch pedal down as far as possible by hand.
- Before removing clutch pedal, remove switch with left turn of 45and pull out from support through mounting hole.
- Insert switch in mounting hole and secure with right turn of 45.
19 - Stop flange
- For clutch pedal
- Installed position. Refer to Installing
20 - Hex nut, self- locking 25 Nm
- Always replace