Installing

WARNING: This page is about a different variant/trim than selected.

Installation is performed in the reverse sequence. When installing note the following:

Fig 1: Identifying Retainer & Clutch Master Cylinder Operating Rod

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Retainer -A- must be on clutch master cylinder operating rod -B-.
Pull piston rod out of master cylinder slightly and hold using a pair of pliers. Avoid damage to piston rod.
Push clutch pedal in direction of arrow to engage it, and make sure it is located correctly.

Fig 2: Installing Stop For Clutch Pedal Again

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Installed position:

Arm (arrow) points toward master cylinder -B-.

After installing clutch master cylinder, bleed clutch system. Refer to Clutch system, bleeding .