Pedal Cluster Assembly, Overview

1 - Bulkhead 

• With support and clutch master cylinder housing

2 - Gasket 

• Always replace

3 - Support 

• For clutch pedal housing

4 - Bolt 

5 - Support 

• For accelerator and brake pedal housing

6 - Hex nut, self-locking 25 Nm 

• Always replace

7 - Connecting plate 

8 - Hex nut, self-locking, 25 Nm 

• Always replace

9 - Mounting bushing 

10 - Mounting pin 

11 - Clutch pedal 

• Removing and installing. Refer to Clutch pedal, removing and installing 

12 - Bearing bracket 

• Removing and installing. Refer to Hydraulic components, assembly overview , item 4

13 - Hex nut, self-locking, 25 Nm 

• Always replace

14 - Clutch master cylinder 

• Removing and installing. Refer to Clutch master cylinder, removing and installing 

15 - Circulation hose 

16 - Over-center spring 

• Removing and installing. Refer to Over-center spring, removing and installing 

17 - Over-center spring seating 

• Install in mounting bracket
• To replace, remove and install clutch master cylinder. Refer to Clutch master cylinder, removing and installing 

18 - Clutch vacuum vent valve switch -F36- 

• When removing and installing switch, push clutch pedal down as far as possible by hand.
• Before removing clutch pedal, remove switch with left turn of 45and pull out from support through mounting hole.
• Insert switch in mounting hole and secure with right turn of 45.

19 - Stop flange 

• For clutch pedal
• Installed position. Refer to Installing 

20 - Hex nut, self- locking 25 Nm 

• Always replace