Installing

Installation is performed in the reverse sequence. When installing note the following:

Fig 1: Identifying Retainer & Clutch Master Cylinder Operating Rod

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Retainer -A- must be on clutch master cylinder operating rod -B-.
• Pull piston rod out of master cylinder slightly and hold using a pair of pliers. Avoid damage to piston rod.
• Push clutch pedal in direction of arrow to engage it, and make sure it is located correctly.

Fig 2: Installing Stop For Clutch Pedal Again

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Install stop -A- for clutch pedal again.

Installed position:

Arm (arrow) points toward master cylinder -B-.

• After installing clutch master cylinder, bleed clutch system. Refer to Clutch system, bleeding  .