Clutch Pedal, Removing And Installing

Special tools and equipment

Fig 1: T10005 Pliers

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Fig 2: Torque Wrench V.A.G. 1331 (5 To 50 Nm)

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Removing

Turn clutch pedal switch 45 to left and pull out from support.
Remove over-center spring. Refer to Over-center spring, removing and installing .
Separate clutch pedal from clutch master cylinder. Refer to Clutch master cylinder, removing and installing and push operating rod toward engine compartment onto stop.

Fig 3: Clutch Pedal Nut

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Installing

Installation is performed in the reverse sequence. Note the following:

Fig 4: Identifying Bearing Bracket & Clutch Master Cylinder Operating Rod

Courtesy of VOLKSWAGEN UNITED STATES, INC.

The bearing bracket -A- must be installed to the clutch master cylinder operating rod -B-.

Install over center spring. Refer to Over-center spring, removing and installing .
Place clutch pedal switch in mounting hole and turn 45 to the right.