Assembling 5th Gear Locking Collar/Synchronizer Hub
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 Volkswagen Jetta, 2009 Volkswagen Jetta, 2008 Volkswagen Jetta, 2007 Volkswagen Jetta, and 2006 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.
-- Slide the locking collar over the synchronizer hub.
The pointed teeth -A- and the shoulder -B- on the synchronizer hub face in the same direction. Recesses for locking pieces in locking collar and synchronizer hub must line up refer to 5th Gear Synchronizer .
-- Insert locking pieces Location: refer to 5th Gear Synchronizer .
-- Install the springs offset by 120° under the tabs -C-. The angled end of the spring must be positioned in front of the locking pieces -arrows-.
NOTE:
Note the location of the springs when using locking pieces with hollow interiors, refer to Installation of Offset Springs -A- .