Installation of Offset Springs -A-

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 Volkswagen Jetta, 2009 Volkswagen Jetta, 2008 Volkswagen Jetta, 2007 Volkswagen Jetta, and 2006 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Offset Springs -A- For 5th Gear Synchronization

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

These springs are installed on both sides.

-- Springs are only installed in conjunction with hollow locking pieces.

-- Insert locking pieces Location: refer to 5th Gear Synchronizer .

Spring installed position:

Fig 2: Installation Position Of (Offset) Spring

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install the circlips 120° offset.

-- Angled end -A- of spring must engage into the hollow locking piece.

It must be located below the tab -B- of the locking pieces.

The offset end always faces away from the synchronizer hub -direction of arrow-.