Muffler with mounts (vehicles with engine codes BJS): Notes
WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2005 Volkswagen GTI, 2004 Volkswagen R32, 2004 Volkswagen Jetta, 2004 Volkswagen GTI, and 2003 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.
Individual components of vacuum control unit. See Individual components of vacuum control unit
1 - Double clamp, 40 Nm
- Installation position of double clamp. See Installation position of double clamps in direction of travel
2 - Connecting brace
3 - M6 - 10 Nm, M8 - 25 Nm, M10 - 40 Nm
4 - Retaining ring
- Gray color identification
- replace if damaged
5 - Front muffler
- Aligning exhaust system. See Aligning exhaust system
6 - Support ring
- With retainer ring
- replace if damaged
7 - Exhaust tail pipe
8 - Tensioning clamp, 40 Nm
9 - Rear muffler
- Installing muffler free of tension
10 - M6 - 10 Nm, M8 - 25 Nm, M10 - 40 Nm
11 - To vacuum control unit
- Component location: Behind left rear wheel housing
- Individual components of vacuum control unit. See Individual components of vacuum control unit
12 - Vacuum actuator
- Check for freedom of movement using V.A.G 1390 hand vacuum pump
13 - Retaining ring
- Red color identification
- replace if damaged