Assembly overview - shift linkage relays on transmission: Notes
WARNING: This page is about a different variant/trim than selected.
The following list pertains to Fig 1.
- Selector rod
- Extract from selector lever housing, see Extracting selector rod with selector lever from selector lever housing
- Bushing
- Bracket
- For relay lever and selector rod support
- Bolt
- 25 N.m (18 ft lb)
- Bracket to steering box
- Bushing
- Relay shaft
- Circlip
- Gate lever
- Shield
- Installation position, see Installation position of shield
- Sealing ring
- Clamp
- Bolt
- Clamp to selector rod
- - Nut
- Self locking
- Always replace
- 20 N.m (15 ft lb)
- Clamp to selector rod
- Intermediate lever
- Nut
- Self locking
- Always replace
- 20 N.m (15 ft lb)
- Intermediate lever to relay lever
- Selector rod, long
- Before removing, use screwdriver to push back clamps on plastic heads
- Bushing
- Selector rod
- Removing and installing, see SELECTOR LEVER AND SELECTOR ROD, REMOVING AND INSTALLING
- Modified, with retainers from 02.94, see Removing and installing selector rod with retainers (arrows)
- Rework if causing complaints, see Reworking selector rod
- Securing spring
- Deleted from 02.94
- Only on selector rods with holes
- Installing, see Reworking selector rod
- Selector lever
- Fits onto selector shaft in only one position
- Nut
- Self locking
- Always replace
- 25 N.m (18 ft lb)
- Lever to selector shaft
- Selector shaft
- Selector rod, short
- Relay lever
- Bolt
- Relay lever to support bracket
- Nut
- Relay lever to support bracket
- Self locking
- Always replace
- 15 N.m (11 ft lb)
- Bushing
- Support bracket
- Not necessary to remove for removal of relay lever