Shock Tower Brace Removal And Installation/Replacement

Mobile Repair Possible:  Van/Car

Removal Procedure: 

1. Remove front trunk. Refer to FRONT TRUNK REMOVAL AND INSTALLATION/REPLACEMENT
2. Remove air inlet grille panel and extension. Refer to AIR INLET GRILLE PANEL AND EXTENSION REMOVAL AND INSTALLATION/REPLACEMENT
3. Remove 4 bolts (1).

   Torque: 56 Nm 

4. Remove 2 bolts (2).

   Torque: 8 Nm 

5. Remove the shock tower brace (3).

Installation Procedure: 

1. Installation is the reverse of removal procedure, noting the following.

   All fasteners must be tightened to torque specification! 

2. Install front trunk. Refer to FRONT TRUNK REMOVAL AND INSTALLATION/REPLACEMENT
3. Install air inlet grille panel and extension. Refer to AIR INLET GRILLE PANEL AND EXTENSION REMOVAL AND INSTALLATION/REPLACEMENT