LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2025 >> Prius Plug-In Hybrid SE >> Repair and Diagnosis >> Suspension >> Rear Suspension >> Suspension System (Rear) - Service Information (1 Of 2) >> REAR LOWER ARM (for AWD RH Side) >> Removal [12/2022 - ] >> Procedure

Removal [12/2022 - ]: Procedure

  1. REMOVE REAR FLOOR SIDE MEMBER COVER LH 

    See step  1, or refer to PROCEDURE - Step 2

  2. REMOVE REAR FLOOR SIDE MEMBER COVER RH 

    See step  2, or refer to PROCEDURE - Step 3

  3. REMOVE REAR WHEEL 

    Refer to REMOVAL [12/2022 - ]

  4. REMOVE REAR STABILIZER BAR 
    Refer to PROCEDURE - Step 5 [12/2022 - 03/2023] , or refer to PROCEDURE - Step 6 [03/2023 - ]
  5. REMOVE REAR COIL SPRING RH 
    • Use the same procedure as for the LH side.

      See step  6 [12/2022 - 03/2023], or See step  7 [03/2023 - ]
  6. REMOVE REAR LOWER COIL SPRING INSULATOR RH 
    • Use the same procedure as for the LH side.

      See step  8 [12/2022 - 03/2023], or See step  9 [03/2023 - ]

  7. REMOVE REAR NO. 2 SUSPENSION ARM ASSEMBLY RH 
    1. GTY1139661Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      1. Remove the nut, No. 2 camber adjust cam, rear suspension toe adjust cam sub-assembly and rear No. 2 suspension arm assembly RH.
        NOTE:

        Hold the rear suspension toe adjust cam sub-assembly while rotating the nut.

  8. REMOVE REAR NO. 1 SUSPENSION ARM ASSEMBLY RH 
    1. GTY1158619Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      1. Remove the 2 bolts, 2 nuts and rear No. 1 suspension arm assembly from the rear axle carrier sub-assembly and rear suspension member sub-assembly RH.
        NOTE:

        Because the nut has its own stopper, do not turn the nut. Loosen the bolt with the nut secured.

scientia non olet · About LEMON Manuals