LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2024 >> Corolla LE >> Repair and Diagnosis >> External Pages >> Different car >> Section 35 (Manual Transaxle System (EG60) - Service Information (1 Of 3)) >> Manual Transaxle Oil >> On-Vehicle Inspection [06/2018 - 11/2022] >> Procedure

On-Vehicle Inspection [06/2018 - 11/2022]: Procedure

WARNING: This page is about a different car, the 2022 Toyota Corolla, 2021 Toyota Corolla, 2020 Toyota Corolla, and 2019 Toyota Corolla. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY 

    Refer to PROCEDURE - Step 9 [06/2018 - 01/2019] , or refer to PROCEDURE - Step 9 [01/2019 - 03/2019] , or refer to PROCEDURE - Step 9 [03/2019 - 09/2019] , or refer to PROCEDURE - Step 9 [09/2019 - 06/2021] , or refer to PROCEDURE - Step 9 [06/2021 - 09/2022] , or refer to PROCEDURE - Step 9 [09/2022 - 11/2022]

  2. REMOVE REAR ENGINE UNDER COVER LH 

    Refer to PROCEDURE - Step 10 [06/2018 - 01/2019] , or refer to PROCEDURE - Step 10 [01/2019 - 03/2019] , or refer to PROCEDURE - Step 10 [03/2019 - 09/2019] , or refer to PROCEDURE - Step 10 [09/2019 - 06/2021] , or refer to PROCEDURE - Step 10 [06/2021 - 09/2022] , or refer to PROCEDURE - Step 10 [09/2022 - 11/2022]

  3. INSPECT MANUAL TRANSAXLE OIL 
    1. Remove the manual transmission filler plug and gasket from the manual transmission case.
      GTY891779Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Check that the oil level is between 0 and 5 mm (0.197 in.) from the bottom lip of the manual transmission filler plug opening.
      GTY447662Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a 0 to 5 mm (0 to 0.197 in.)
      NOTE:

      An excessively large or small amount of manual transaxle oil may cause problems.

    3. Check for oil leakage when the oil level is low.
    4. Install a new gasket and the manual transmission filler plug to the manual transmission case.
      GTY891779Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Torque: 39.2 N.m (400 kgf/cm, 29 ft.lbf) 

  4. INSTALL REAR ENGINE UNDER COVER LH 

    Refer to PROCEDURE - Step 80 [06/2018 - 01/2019] , or refer to PROCEDURE - Step 80 [01/2019 - 03/2019] , or refer to PROCEDURE - Step 80 [03/2019 - 09/2019] , or refer to PROCEDURE - Step 83 [09/2019 - 06/2021] , or refer to PROCEDURE - Step 83 [06/2021 - 09/2022] , or refer to PROCEDURE - Step 83 [09/2022 - 11/2022]

  5. INSTALL NO. 1 ENGINE UNDER COVER ASSEMBLY 

    Refer to PROCEDURE - Step 82 [06/2018 - 01/2019] , or refer to PROCEDURE - Step 82 [01/2019 - 03/2019] , or refer to PROCEDURE - Step 82 [03/2019 - 09/2019] , or refer to PROCEDURE - Step 85 [09/2019 - 06/2021] , or refer to PROCEDURE - Step 85 [06/2021 - 09/2022] , or refer to PROCEDURE - Step 85 [09/2022 - 11/2022]