Removal [10/2022 - ]: Procedure

PRECAUTION
NOTE:
After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) auxiliary battery terminal.

Refer to BEFORE DISCONNECTING BATTERY [10/2022 - ]
REMOVE REAR NO. 2 FLOOR BOARD
Refer to PROCEDURE - Step 2
REMOVE BATTERY HOLE COVER
Refer to PROCEDURE - Step 6
DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
Refer to PROCEDURE - Step 4
REMOVE REAR DOOR INSIDE HANDLE BEZEL
Refer to PROCEDURE - Step 5
REMOVE REAR DOOR ARMREST COVER
Refer to PROCEDURE - Step 6
REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY
Refer to PROCEDURE - Step 7
REMOVE REAR DOOR INNER GLASS WEATHERSTRIP
Refer to PROCEDURE - Step 10
REMOVE REAR DOOR REAR BELT SEAL
Refer to PROCEDURE - Step 12
REMOVE REAR DOOR SERVICE HOLE COVER
Refer to PROCEDURE - Step 14
REMOVE REAR DOOR GLASS RUN
Refer to PROCEDURE - Step 16
REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY
Refer to PROCEDURE - Step 17
REMOVE REAR DOOR QUARTER WINDOW GLASS
Refer to PROCEDURE - Step 18
REMOVE HOLE PLUG
Refer to PROCEDURE - Step 20
REMOVE REAR DOOR GLASS SUB-ASSEMBLY
Refer to PROCEDURE - Step 21

REMOVE REAR DOOR BELT MOULDING ASSEMBLY

Apply protective tape around the rear door belt moulding assembly as shown in the illustration.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Protective Tape

Disengage the 7 claws to remove the rear door belt moulding assembly as shown in the illustration.

Remove in this Direction