LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2021 >> RAV4 LE, AWD >> Repair and Diagnosis >> Body & Frame >> Seats >> Seats - Service Information (2 Of 5) >> Rear Seat Assembly >> Disassembly [11/2018 - ] >> Procedure

Disassembly [11/2018 - ]: Procedure

  1. REMOVE BENCH TYPE REAR SEAT CUSHION COVER 
    1. Detach the hook.
      1. for Gasoline Model:
        GTY935063Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      2. for HV Model:
        GTY859702Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Using a thin-bladed screwdriver, detach the hook to remove the bench type rear seat cushion cover from the rear seat cushion pad as shown in the illustration.
      GTY904567Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Protective Tape - -
      NOTE:

      Be careful not to dirty or damage the bench type rear seat cushion cover.

      HINT: 

      Tape the thin-bladed screwdriver tip before use.

  2. REMOVE REAR SEAT CUSHION HEATER ASSEMBLY LH (w/ Seat Heater System) 

    Refer to PROCEDURE - Step 4

  3. REMOVE REAR SEAT CUSHION HEATER ASSEMBLY RH (w/ Seat Heater System) 

    HINT: 

    Use the same procedure described for the LH side.

  4. REMOVE REAR SEAT HEADREST ASSEMBLY 
    1. Remove the 2 rear seat headrest assemblies.
  5. REMOVE REAR CENTER SEAT HEADREST ASSEMBLY 
    1. Remove the rear center seat headrest assembly.
  6. REMOVE REAR LOWER SEATBACK LOCK BEZEL LH (for LH Side) 
    1. Using a moulding remover D, detach the claw.
      GTY854768Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Remove in this Direction
    2. Pull in the removal direction shown in the illustration to detach the guide and remove the rear lower seatback lock bezel LH.
  7. REMOVE REAR UPPER SEATBACK LOCK BEZEL LH (for LH Side) 
    1. Using a moulding remover D, detach the claw.
      GTY935713Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Remove in this Direction
      Protective Tape
    2. Using a thin-bladed screwdriver, detach the claw on the rear side and remove the rear upper seatback lock bezel LH.

      HINT: 

      Tape the thin-bladed screwdriver tip before use.

  8. REMOVE REAR SEATBACK BOARD SUB-ASSEMBLY LH (for LH Side) 
    1. Detach the hook.
      GTY904300Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Detach the hook.
      GTY904286Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Pull out the 2 fasteners from the hole of rear seatback board sub-assembly LH.
      GTY940752Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Open the 2 fasteners.
    5. Remove the clip.
    6. Remove the 2 clips.
      GTY904283Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    7. Pull in the removal direction (1) shown in the illustration to detach the claw.
      GTY896150Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Guide
      *b Hook
      Remove in this Direction (1)
      Remove in this Direction (2)
      Remove in this Direction (3)
    8. Pull in the removal direction (2) shown in the illustration to detach the guide.
    9. Pull in the removal direction (3) shown in the illustration to detach the hook and remove the rear seatback board sub-assembly LH.
  9. REMOVE SEPARATE TYPE REAR SEATBACK COVER WITH PAD (for LH Side) 
    1. Detach the claw and remove the 2 rear seat headrest supports.
      GTY904385Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the separate type rear seatback cover with pad from the rear seatback frame sub-assembly LH.
  10. REMOVE SEPARATE TYPE REAR SEATBACK COVER LH (for LH Side) 
    1. Using a thin-bladed screwdriver, detach the hook to remove the separate type rear seatback cover LH from the separate type rear seatback pad LH as shown in the illustration.
      GTY913431Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Protective Tape
      NOTE:

      Be careful not to dirty or damage the separate type rear seatback cover.

      HINT: 

      Tape the thin-bladed screwdriver tip before use.

  11. REMOVE REAR SEATBACK HEATER ASSEMBLY LH (for LH Side, w/ Seat Heater System) 

    Refer to PROCEDURE - Step 13

  12. REMOVE REAR SEATBACK LOCK ASSEMBLY LH (for LH Side) 
    1. Remove the 2 screws.
      GTY904377Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the 3 bolts and rear seatback lock assembly LH.
      GTY904369Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      HINT: 

      Remove the rear seat lock control lever sub-assembly LH together with the rear seatback lock assembly LH.

  13. REMOVE REAR SEAT LOCK CONTROL LEVER SUB-ASSEMBLY LH (for LH Side) 
    1. Detach the hook and remove the rear seat lock control lever sub-assembly LH from the rear seatback lock assembly LH.
      GTY904376Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  14. REMOVE SEAT BELT ANCHOR COVER CAP (for RH Side) 
    1. Using a moulding remover D, detach the claw.
      GTY906734Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Remove in this Direction
    2. Pull in the removal direction shown in the illustration to detach the guide.
    3. Detach the guide to remove the seat belt anchor cover cap as shown in the illustration.
      GTY918759Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Remove in this Direction
  15. REMOVE REAR SEAT SHOULDER BELT COVER (for RH Side) 
    1. Pass the rear center seat outer belt assembly from the slit and remove the rear seat shoulder belt cover.
      GTY904299Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  16. REMOVE REAR LOWER SEATBACK LOCK BEZEL RH (for RH Side) 
    1. Using a moulding remover D, detach the claw.
      GTY933348Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Remove in this Direction
    2. Pull in the removal direction shown in the illustration to detach the guide and remove the rear lower seatback lock bezel RH.
  17. REMOVE REAR UPPER SEATBACK LOCK BEZEL RH (for RH Side) 
    1. Using a moulding remover D, detach the claw.
      GTY894368Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Remove in this Direction
      Protective Tape
    2. Using a thin-bladed screwdriver, detach the claw on the rear side and remove the rear upper seatback lock bezel RH.

      HINT: 

      Tape the thin-bladed screwdriver tip before use.

  18. REMOVE REAR SEATBACK BOARD SUB-ASSEMBLY RH (for RH Side) 
    1. Detach the hook.
      GTY904285Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Detach the hook.
      GTY904284Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Pull out the 2 fasteners from the hole of rear seatback board sub-assembly RH.
      GTY904282Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Open the 2 fasteners.
    5. Remove the 2 clips.
      GTY904295Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    6. Pull in the removal direction (1) shown in the illustration to detach the claw.
      GTY843902Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Guide
      *b Hook
      Remove in this Direction (1)
      Remove in this Direction (2)
      Remove in this Direction (3)
    7. Pull in the removal direction (2) shown in the illustration to detach the guide.
    8. Pull in the removal direction (3) shown in the illustration to detach the hook and remove the rear seatback board sub-assembly RH.
  19. REMOVE CENTER ARMREST HINGE COVER (for RH Side) 
    1. Fold the rear center seat armrest assembly forward.
    2. Using a thin-bladed screwdriver, detach the claw on the rear side.

      HINT: 

      Tape the thin-bladed screwdriver tip before use.

      GTY927627Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Remove in this Direction
      Protective Tape
    3. Pull in the removal direction shown in the illustration and detach the claw and guide to remove the center armrest hinge cover.
  20. REMOVE REAR CENTER SEAT ARMREST ASSEMBLY (for RH Side) 
    1. Remove the bolt and washer.
      GTY904380Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Return the rear center seat armrest assembly to rotate the outside location pin to the position as shown in the illustration.
      GTY862084Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Outside Location Pin - -
      Rotate - -
    3. Detach the outside location pin in the removal direction (1) shown in the illustration.
      GTY867941Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Outside Location Pin
      *b Inside Location Pin
      Remove in this Direction (1)
      Remove in this Direction (2)
    4. Detach the inside location pin in the removal direction (2) shown in the illustration and remove the rear center seat armrest assembly.
    5. Remove the bush.
      GTY940773Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  21. REMOVE SEPARATE TYPE REAR SEATBACK COVER WITH PAD (for RH Side) 
    1. Detach the claw and remove the 4 rear seat headrest supports.
      GTY904386Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Detach the hook.
      GTY904374Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Pass the rear center seat outer belt assembly through the hole of separate type rear seatback cover with pad.
      GTY904370Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Remove the separate type rear seatback cover with pad from the rear seatback frame sub-assembly RH.
  22. REMOVE SEPARATE TYPE REAR SEATBACK COVER RH (for RH Side) 
    1. Using a thin-bladed screwdriver, detach the hook to remove the separate type rear seatback cover RH from the separate type rear seatback pad RH as shown in the illustration.
      GTY914453Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Protective Tape
      NOTE:

      Be careful not to dirty or damage the separate type rear seatback cover.

      HINT: 

      Tape the thin-bladed screwdriver tip before use.

  23. REMOVE REAR SEATBACK HEATER ASSEMBLY RH (for RH Side, w/ Seat Heater System) 

    Refer to PROCEDURE - Step 23

  24. REMOVE REAR CENTER SEAT OUTER BELT ASSEMBLY (for RH Side) 

    Refer to PROCEDURE - Step 15

  25. REMOVE REAR SEATBACK LOCK ASSEMBLY RH (for RH Side) 
    1. Remove the 2 screws.
      GTY904375Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the 3 bolts and rear seatback lock assembly RH.
      GTY940771Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      HINT: 

      Remove the rear seat lock control lever sub-assembly RH together with the rear seatback lock assembly RH.

  26. REMOVE REAR SEAT LOCK CONTROL LEVER SUB-ASSEMBLY RH (for RH Side) 
    1. Detach the hook and remove the rear seat lock control lever sub-assembly RH from the rear seatback lock assembly RH.
      GTY940772Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals