LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2021 >> Prius Prime LE >> Repair and Diagnosis >> Accessories & Equipment >> Infotainment >> Navigation System - Service Information >> Navigation Receiver >> Removal [09/2016 - 05/2019] >> Procedure

Removal [09/2016 - 05/2019]: Procedure

  1. PRECAUTION 
    NOTE:

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

    Refer to PRECAUTION [09/2016 - 01/2018] , or refer to PRECAUTION [01/2018 - 05/2019]

    Refer to PRECAUTION [09/2016 - 07/2020]

  2. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL 

    Refer to PROCEDURE - Step 2

  3. REMOVE INSTRUMENT PANEL FINISH PANEL END RH 

    Refer to PROCEDURE - Step 14

  4. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY (for 7 Inch Display) 

    Refer to PROCEDURE - Step 15

  5. REMOVE NAVIGATION RECEIVER ASSEMBLY WITH BRACKET (for 7 Inch Display) 
    1. Remove the 4 bolts.
      GTY562120Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Pull the navigation receiver assembly with bracket toward the rear of the vehicle and disengage the 2 guides.
      GTY540616Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Remove in this Direction
    3. Disconnect each connector and remove the navigation receiver assembly with bracket.
  6. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL UPPER (for 11.6 Inch Display) 

    Refer to PROCEDURE - Step 16

  7. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY WITH NAVIGATION RECEIVER ASSEMBLY (for 11.6 Inch Display) 

    Refer to PROCEDURE - Step 17

  8. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY (for 11.6 Inch Display) 
    1. Disconnect the connector.
      GTY689290Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the 3 screws.
    3. Disengage the 7 guides to remove the instrument cluster finish panel sub-assembly as shown in the illustration.
      GTY704532Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Remove in this Direction
  9. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY (for 11.6 Inch Display) 
    1. Remove the 3 screws.
      GTY689294Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disengage the 7 guides to remove the center instrument cluster finish panel sub-assembly as shown in the illustration.
      GTY715231Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Remove in this Direction
  10. DISCONNECT STEREO COMPONENT TUNER ASSEMBLY WITH WIRE (w/ Satellite Radio) 
    1. for 7 Inch Display:
      1. Disconnect the 3 connectors to disconnect the stereo component tuner assembly with wire.
        GTY562121Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. for 11.6 Inch Display:
      1. Disengage the clamp.
        GTY689297Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      2. Disconnect the 3 connectors to disconnect the stereo component tuner assembly with wire.
  11. REMOVE HAZARD WARNING SIGNAL SWITCH ASSEMBLY (for 11.6 Inch Display) 
    1. Disengage the 2 claws to remove the hazard warning signal switch assembly.
      GTY726473Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  12. REMOVE NO. 1 RADIO BRACKET (for 7 Inch Display) 
    1. w/o Satellite Radio:
      1. Remove the 3 screws and No. 1 radio bracket.
        GTY562132Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. w/ Satellite Radio:
      1. Remove the 5 screws and No. 1 radio bracket.
        GTY562130Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  13. REMOVE NO. 1 RADIO BRACKET (for 11.6 Inch Display) 
    1. w/o Satellite Radio:
      1. Remove the 3 screws and No. 1 radio bracket.
        GTY688671Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. w/ Satellite Radio:
      1. Remove the 5 screws and No. 1 radio bracket.
        GTY688687Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  14. REMOVE NO. 2 RADIO BRACKET (for 7 Inch Display) 
    1. w/o Satellite Radio:
      1. Remove the 3 screws and No. 2 radio bracket.
        GTY602753Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. w/ Satellite Radio:
      1. Remove the 5 screws and No. 2 radio bracket.
        GTY562133Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  15. REMOVE NO. 2 RADIO BRACKET (for 11.6 Inch Display) 
    1. w/o Satellite Radio:
      1. Remove the 3 screws and No. 2 radio bracket.
        GTY688688Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. w/ Satellite Radio:
      1. Remove the 5 screws and No. 2 radio bracket.
        GTY688689Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  16. REMOVE NAVIGATION RECEIVER ASSEMBLY 
  17. REMOVE STEREO COMPONENT TUNER ASSEMBLY WITH WIRE (w/ Satellite Radio)