Removal [08/2015 - ]: Procedure

DISABLE AUTOAWAY/RETURN FUNCTION
1. Disable the autoaway/return function by changing the customize parameter (Refer to CUSTOMIZE PARAMETERS [08/2015 - ] ).
  WARNING:
  Record the current customize parameter setting (whether the autoaway/return function is enabled or disabled) in order to restore the current setting after finishing the operation.
  
  HINT:
  
  Performing the above operation causes the autoaway/return function to be disabled when the engine switch is turned off.
2. Turn the engine switch on (IG). Operate the tilt and telescopic switch to fully extend and lower the steering column assembly.
3. Turn the engine switch off.
REMOVE NO. 2 INSTRUMENT PANEL FINISH PANEL CUSHION
Refer to PROCEDURE - Step 1 [08/2015 - ]
REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY LH
Refer to PROCEDURE - Step 2 [08/2015 - ]
REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH
Refer to PROCEDURE - Step 12 [08/2015 - ]
REMOVE NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH
Refer to PROCEDURE - Step 13 [08/2015 - ]
REMOVE NO. 2 INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
See step 6
REMOVE LIGHT CONTROL RHEOSTAT

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
1. Using a screwdriver, detach the 2 claws and remove the light control rheostat.
  HINT:
  
  Tape the screwdriver tip before use.
  TEXT IN ILLUSTRATION
  
  *a Protective Tape