LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2021 >> Camry LE, FWD >> Repair and Diagnosis >> Restraints >> Seat Belts >> Seat Belt - Service Information (Except Hybrid) >> Child Restraint Seat Tether Anchor >> Installation [06/2017 - 09/2019] >> Procedure

Installation [06/2017 - 09/2019]: Procedure

  1. INSTALL CHILD RESTRAINT SEAT TETHER ANCHOR BRACKET 

    HINT: 

    Use the same procedure for all child restraint seat tether anchor brackets.

    1. Engage the guide and install the child restraint seat tether anchor bracket with the bolt.

      Torque: 21 N*m (214 kgf*cm, 15 ft.*lbf) 

  2. INSTALL PACKAGE TRAY TRIM PANEL ASSEMBLY 

    See step  5

  3. INSTALL REAR SEAT SHOULDER BELT HOLE COVER 

    See step  6

  4. INSTALL CENTER STOP LIGHT SET 

    Refer to INSTALLATION [03/2017 - ]

  5. CONNECT REAR SEAT OUTER BELT ASSEMBLY LH 

    See step  8

  6. CONNECT REAR SEAT OUTER BELT ASSEMBLY RH 

    HINT: 

    Use the same procedure as for the LH side.

  7. INSTALL INNER ROOF SIDE GARNISH LH 

    Refer to PROCEDURE - Step 21 [06/2017 - 08/2018] , or refer to PROCEDURE - Step 21 [08/2018 - 09/2019]

  8. INSTALL INNER ROOF SIDE GARNISH RH 

    HINT: 

    Use the same procedure as for the LH side.

  9. INSTALL REAR SIDE SEATBACK ASSEMBLY LH (for Fold Down Seat Type) 

    Refer to PROCEDURE - Step 1

  10. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP LH (for Fold Down Seat Type) 

    Refer to PROCEDURE - Step 26 [06/2017 - 08/2018] , or refer to PROCEDURE - Step 26 [08/2018 - 09/2019]

  11. INSTALL REAR SIDE SEATBACK ASSEMBLY RH (for Fold Down Seat Type) 

    HINT: 

    Use the same procedure as for the LH side.

  12. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP RH (for Fold Down Seat Type) 

    Refer to PROCEDURE - Step 37 [06/2017 - 08/2018] , or refer to PROCEDURE - Step 37 [08/2018 - 09/2019]

  13. INSTALL REAR SEAT CUSHION LOCK HOOK (for Fold Down Seat Type) 

    Refer to PROCEDURE - Step 7

  14. INSTALL REAR SEAT CUSHION ASSEMBLY (for Fold Down Seat Type) 

    For TMC Made:

    Refer to PROCEDURE - Step 11

    For TMMK Made:

    Refer to PROCEDURE - Step 8

  15. CONNECT REAR CENTER SEAT OUTER BELT ASSEMBLY (for Fold Down Seat Type) 

    For TMC Made:

    Refer to PROCEDURE - Step 12

  16. INSTALL REAR SEAT ASSEMBLY (for Fixed Seat Type) 

    Refer to INSTALLATION [06/2017 - ]

  17. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 

    For A25A-FKS:

    Refer to PROCEDURE - Step 2 [03/2017 - 08/2018] , or refer to PROCEDURE - Step 2 [08/2018 - ]

    For 2GR-FKS:

    Refer to PROCEDURE - Step 2

  18. PERFORM DIAGNOSTIC SYSTEM CHECK 

    Refer to DTC CHECK / CLEAR [03/2017 - ]

  19. INSPECT SRS WARNING LIGHT 

    Refer to OPERATION CHECK [06/2017 - 09/2019]

scientia non olet · About LEMON Manuals