Installation [03/2017 - ]: Procedure

1. Insert the stop light switch assembly until the threaded sleeve hits the pedal.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   NOTE:

   When inserting the stop light switch assembly, support the pedal from behind so that the pedal is not pushed in.

2. Turn the stop light switch assembly 1/4 clockwise to install it.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Torque: 1.5 N*m (15 kgf*cm, 13 in.*lbf) 

   or less

   NOTE:

   When inserting the stop light switch assembly, support the pedal from behind so that the pedal is not pushed in.

3. Connect the connector.
4. Check the protrusion of the plunger.
   PROTRUSION OF THE PLUNGER
   
   

   Area	Measurement
   a	0.6 to 2.6 mm (0.0236 to 0.102 in.)

5. If the protrusion is not as specified, recheck the stop light switch assembly installation and perform brake pedal adjustment if necessary.

   Refer to ADJUSTMENT [03/2017 - 06/2017] , or refer to ADJUSTMENT [06/2017 - 10/2020] , or refer to ADJUSTMENT [10/2020 - 08/2021] , or refer to ADJUSTMENT [08/2021 - ]

   NOTE:

   Do not depress or support the brake pedal.

Refer to PROCEDURE - Step 28 [03/2017 - 06/2017] , or refer to PROCEDURE - Step 28 [06/2017 - 10/2020] , or refer to PROCEDURE - Step 31 [10/2020 - ]