LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2021 >> Avalon TRD >> Repair and Diagnosis >> Electrical >> Gauges >> Meter / Gauge / Display (Service Information) >> Combination Meter >> Removal [04/2018 - 08/2020] >> Procedure

Removal [04/2018 - 08/2020]: Procedure

  1. PRECAUTION 
    NOTE:

    After turning the engine switch (for Gasoline Model) or power switch (for HV Model) off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

    Refer to PRECAUTION [04/2018 - ]

  2. CHANGE POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM SETTINGS (for Power Tilt and Power Telescopic Steering Column) 

    Refer to PROCEDURE - Step 2

  3. REMOVE LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY 

    Refer to REMOVAL [04/2018 - 08/2020]

  4. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL LH 

    Refer to PROCEDURE - Step 3

  5. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL RH 

    Refer to PROCEDURE - Step 4

  6. REMOVE FRONT CONSOLE UPPER PANEL GARNISH 

    Refer to PROCEDURE - Step 5

  7. REMOVE CONSOLE BOX POCKET SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 6

  8. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 7

  9. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 1

  10. REMOVE REAR UPPER CONSOLE PANEL SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 9

  11. REMOVE CONSOLE BOX BEZEL 

    Refer to PROCEDURE - Step 11

  12. REMOVE CENTER NO. 1 INSTRUMENT CLUSTER FINISH PANEL 

    Refer to PROCEDURE - Step 13

  13. REMOVE CENTER NO. 2 INSTRUMENT CLUSTER FINISH PANEL 

    Refer to PROCEDURE - Step 14

  14. REMOVE RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKET 

    Refer to PROCEDURE - Step 9

  15. REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 24

  16. REMOVE LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL 

    Refer to PROCEDURE - Step 11

  17. REMOVE LOWER CENTER INSTRUMENT PANEL FINISH PANEL 

    Refer to PROCEDURE - Step 25

  18. REMOVE INSTRUMENT CLUSTER FINISH PANEL GARNISH ASSEMBLY 

    Refer to PROCEDURE - Step 29

  19. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY 

    Refer to PROCEDURE - Step 30

  20. REMOVE NO. 1 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 31

  21. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 32

  22. REMOVE COMBINATION METER ASSEMBLY 
    1. Remove the 3 screws.
      GTY944088Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disengage the 2 clips as shown in the illustration.
      GTY854372Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Remove in this Direction
    3. Disengage the clamp.
      GTY919361Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Disconnect the 2 connectors to remove the combination meter assembly.
scientia non olet · About LEMON Manuals