Installation [08/2015 - ]: Procedure

INSTALL LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY

Connect the connector.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NOTE:

When handling the airbag connector, take care not to damage the airbag wire harness.

INSTALL LOWER INSTRUMENT COVER LH
Refer to PROCEDURE - Step 17 [08/2015 - 08/2019] , or refer to PROCEDURE - Step 16 [08/2019 - 08/2022] , or refer to PROCEDURE - Step 16 [08/2022 - ]
INSTALL FRONT NO. 2 CONSOLE BOX INSERT
Refer to PROCEDURE - Step 7 [08/2015 - 08/2019] , or refer to PROCEDURE - Step 7 [08/2019 - ]
INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 18 [08/2015 - 08/2019] , or refer to PROCEDURE - Step 17 [08/2019 - 08/2022] , or refer to PROCEDURE - Step 17 [08/2022 - ]
INSTALL NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH
Refer to PROCEDURE - Step 3
INSTALL COWL SIDE TRIM BOARD RH
Refer to PROCEDURE - Step 32 [08/2015 - 08/2019] , or refer to PROCEDURE - Step 31 [08/2019 - 08/2022] , or refer to PROCEDURE - Step 31 [08/2022 - ]
INSTALL DOOR SCUFF PLATE ASSEMBLY RH
HINT:

Use the same procedure as for the LH side (Refer to PROCEDURE - Step 77 [08/2015 - 08/2019] , or refer to PROCEDURE - Step 78 [08/2019 - ] ).
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Refer to INITIALIZATION [08/2015 - 08/2019] , or refer to INITIALIZATION [08/2019 - 08/2022] , or refer to INITIALIZATION [08/2022 - ] ).
CHECK SRS WARNING LIGHT
1. Check the SRS warning light (Refer to DIAGNOSIS SYSTEM [08/2015 - 08/2019] , or refer to DIAGNOSIS SYSTEM [08/2019 - ] ).