Installation [08/2015 - ]: Procedure

INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

Connect the connector.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NOTE:

When handling the airbag connector, take care not to damage the airbag wire harness.

Install the airbag assembly with the 4 bolts.
Torque: 10 N.m (102 kgf/cm, 7 ft.lbf)

INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY
Refer to PROCEDURE - Step 20 [08/2015 - 08/2019] , or refer to PROCEDURE - Step 19 [08/2019 - 08/2022] , or refer to PROCEDURE - Step 19 [08/2022 - ]
INSTALL NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH
Refer to PROCEDURE - Step 8 [08/2015 - 08/2019] , or refer to PROCEDURE - Step 8 [08/2019 - ]
INSTALL COWL SIDE TRIM BOARD LH
Refer to PROCEDURE - Step 75 [08/2015 - 08/2019] , or refer to PROCEDURE - Step 76 [08/2019 - ]
INSTALL DOOR SCUFF PLATE ASSEMBLY LH
Refer to PROCEDURE - Step 77 [08/2015 - 08/2019] , or refer to PROCEDURE - Step 78 [08/2019 - ]
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Refer to INITIALIZATION [08/2015 - 08/2019] , or refer to INITIALIZATION [08/2019 - 08/2022] , or refer to INITIALIZATION [08/2022 - ] ).
CHECK SRS WARNING LIGHT
1. Check the SRS warning light (Refer to DIAGNOSIS SYSTEM [08/2015 - 08/2019] , or refer to DIAGNOSIS SYSTEM [08/2019 - ] ).