LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2021 >> 4Runner TRD Pro >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Interior Panels / Trim - Service Information >> Instrument Panel Safety Pad >> Reassembly [08/2015 - 08/2019] >> Procedure

Reassembly [08/2015 - 08/2019]: Procedure

  1. INSTALL NAVIGATION ANTENNA ASSEMBLY (w/ Navigation System) 

    Refer to PROCEDURE - Step 1

  2. INSTALL AUTOMATIC LIGHT CONTROL SENSOR 

    Refer to PROCEDURE - Step 1

  3. INSTALL INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY 

    Refer to PROCEDURE - Step 1

  4. INSTALL NO. 2 INSTRUMENT PANEL WIRE 
    1. Attach the 17 clamps to install the No. 2 instrument panel wire.
    2. Connect the connector.
  5. INSTALL TELLTALE LIGHT ASSEMBLY 

    Refer to PROCEDURE - Step 1

  6. INSTALL ACCESSORY METER ASSEMBLY 

    Refer to PROCEDURE - Step 1

  7. INSTALL DEFROSTER NOZZLE ASSEMBLY 
    1. Install the defroster nozzle assembly with the 3 screws.
  8. INSTALL NO. 3 HEATER TO REGISTER DUCT 
    1. Attach the claw.
    2. Install the No. 3 heater to register duct with the 2 screws.
  9. INSTALL NO. 2 SIDE DEFROSTER NOZZLE DUCT 
    1. Attach the 2 claws.
    2. Install the No. 2 side defroster nozzle duct with the screw.
  10. INSTALL NO. 1 SIDE DEFROSTER NOZZLE DUCT 
    1. Attach the 2 claws.
    2. Install the No. 1 side defroster nozzle duct with the screw.
  11. INSTALL NO. 2 HEATER TO REGISTER DUCT 
    1. Install the No. 2 heater to register duct with the 4 screws.
  12. INSTALL NO. 1 HEATER TO REGISTER DUCT 
    1. Install the No. 1 heater to register duct with the 4 screws.
scientia non olet · About LEMON Manuals