LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2020 >> Prius XLE >> Repair and Diagnosis >> External Pages >> Different car >> Section 168 (Meter / Gauge / Display (Service Information)) >> Combination Meter >> Removal [04/2018 - 08/2020] >> Procedure

Removal [04/2018 - 08/2020]: Procedure

WARNING: This page is about a different car, the 2022 Toyota Avalon, 2021 Toyota Avalon, 2020 Toyota Avalon, and 2019 Toyota Avalon. However, it is still accessible from the selected car via links, so may be relevant.
  1. PRECAUTION 
    NOTE:

    After turning the engine switch (for Gasoline Model) or power switch (for HV Model) off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

    Refer to PRECAUTION [04/2018 - ]

  2. CHANGE POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM SETTINGS (for Power Tilt and Power Telescopic Steering Column) 

    Refer to PROCEDURE - Step 2

  3. REMOVE LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY 

    Refer to REMOVAL [04/2018 - 08/2020]

  4. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL LH 

    Refer to PROCEDURE - Step 3

  5. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL RH 

    Refer to PROCEDURE - Step 4

  6. REMOVE FRONT CONSOLE UPPER PANEL GARNISH 

    Refer to PROCEDURE - Step 5

  7. REMOVE CONSOLE BOX POCKET SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 6

  8. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 7

  9. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 1

  10. REMOVE REAR UPPER CONSOLE PANEL SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 9

  11. REMOVE CONSOLE BOX BEZEL 

    Refer to PROCEDURE - Step 11

  12. REMOVE CENTER NO. 1 INSTRUMENT CLUSTER FINISH PANEL 

    Refer to PROCEDURE - Step 13

  13. REMOVE CENTER NO. 2 INSTRUMENT CLUSTER FINISH PANEL 

    Refer to PROCEDURE - Step 14

  14. REMOVE RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKET 

    Refer to PROCEDURE - Step 9

  15. REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 24

  16. REMOVE LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL 

    Refer to PROCEDURE - Step 11

  17. REMOVE LOWER CENTER INSTRUMENT PANEL FINISH PANEL 

    Refer to PROCEDURE - Step 25

  18. REMOVE INSTRUMENT CLUSTER FINISH PANEL GARNISH ASSEMBLY 

    Refer to PROCEDURE - Step 29

  19. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY 

    Refer to PROCEDURE - Step 30

  20. REMOVE NO. 1 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 31

  21. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 32

  22. REMOVE COMBINATION METER ASSEMBLY 
    1. Remove the 3 screws.
      GTY944088Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disengage the 2 clips as shown in the illustration.
      GTY854372Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Remove in this Direction
    3. Disengage the clamp.
      GTY919361Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Disconnect the 2 connectors to remove the combination meter assembly.
scientia non olet · About LEMON Manuals