LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2020 >> Avalon Limited >> Repair and Diagnosis >> Body & Frame >> Exterior/Interior Trim >> EXTERIOR PANELS / TRIM (SERVICE INFORMATION) (2 Of 2) >> Front Bumper >> Disassembly [04/2018 - 08/2019] >> Procedure

Disassembly [04/2018 - 08/2019]: Procedure

  1. REMOVE FRONT TELEVISION CAMERA ASSEMBLY (w/ Panoramic View Monitor System) 

    Refer to PROCEDURE - Step 2

  2. REMOVE FRONT CENTER ULTRASONIC SENSOR (w/ Intuitive Parking Assist System) 

    Refer to PROCEDURE - Step 2

    HINT: 

    Use the same procedure for the RH side and LH side.

  3. REMOVE FRONT CORNER ULTRASONIC SENSOR (w/ Intuitive Parking Assist System) 

    Refer to PROCEDURE - Step 3

    HINT: 

    Use the same procedure for the RH side and LH side.

  4. REMOVE NO. 4 ENGINE ROOM WIRE (w/ Intuitive Parking Assist System) 
    1. Disengage the 11 clamps to remove the No. 4 engine room wire.
      GTY863618Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  5. REMOVE FRONT LICENSE PLATE BRACKET SUB-ASSEMBLY (for Bar Type Radiator Grille) 
    1. Remove the 4 screws.
      GTY863691Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the front license plate bracket sub-assembly as shown in the illustration.
      GTY904811Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Remove in this Direction
  6. REMOVE FRONT LICENSE PLATE BRACKET SUB-ASSEMBLY (for Mesh Type Radiator Grille) 
    1. Remove the 4 screws.
      GTY931799Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the front license plate bracket sub-assembly as shown in the illustration.
      GTY842202Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Remove in this Direction
  7. REMOVE AIR INTAKE DUCT LH 
    1. Remove the 2 screws and clip.
      GTY851462Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Screw
      Clip
    2. Disengage the 4 guides to remove the air intake duct LH as shown in the illustration.
      GTY866674Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Remove in this Direction (1)
      Remove in this Direction (2)
  8. REMOVE AIR INTAKE DUCT RH 

    HINT: 

    Use the same procedure as for the LH side.

  9. REMOVE MILLIMETER WAVE RADAR SENSOR ASSEMBLY 

    Refer to PROCEDURE - Step 2

  10. REMOVE HOOD TO FRONT END PANEL SEAL 
    1. Disengage the 4 clips.
      GTY857073Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Double-sided Tape
    2. Separate the double-sided tape and remove the hood to front end panel seal.
  11. REMOVE RADIATOR GRILLE EMBLEM ASSEMBLY 
    1. Remove the 2 screws.
      GTY931781Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disengage the 2 claws to remove the radiator grille emblem assembly.
  12. REMOVE RADIATOR GRILLE SUB-ASSEMBLY 
    1. Remove the 3 screws and 2 clips.
      GTY878155Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Screw
      Clip
    2. Remove the 8 screws.
      GTY863615Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Disengage the 4 claws and guide to remove the radiator grille sub-assembly.
      GTY863616Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  13. REMOVE LOWER RADIATOR GRILLE SUB-ASSEMBLY (for Bar Type Radiator Grille) 
    1. Remove the 8 screws.
      GTY863614Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disengage the 23 claws and 5 guides to remove the lower radiator grille sub-assembly.
      GTY931798Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  14. REMOVE LOWER RADIATOR GRILLE SUB-ASSEMBLY (for Mesh Type Radiator Grille) 
    1. Remove the 8 screws.
      GTY873177Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disengage the 23 claws and 3 guides to remove the lower radiator grille sub-assembly.
      GTY933879Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  15. REMOVE RADIATOR GRILLE (for Bar Type Radiator Grille) 
    1. Remove the screw.
      GTY863686Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disengage the 6 claws and 6 guides to remove the radiator grille.
      GTY863687Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  16. REMOVE FRONT BUMPER MOULDING (for Bar Type Radiator Grille) 
    1. Remove the 6 screws.
      GTY863677Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disengage the 18 claws and 20 guides to remove the front bumper moulding.
      GTY863678Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  17. REMOVE FRONT BUMPER SIDE RETAINER LH 
    1. Remove the bolt (A) and bolt (B).
      GTY896325Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Bolt (A)
      Bolt (B)
    2. Disengage the clip as shown in the illustration.
      GTY893433Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Remove in this Direction (1)
      Remove in this Direction (2)
    3. Disengage the claw to remove the front bumper side retainer LH as shown in the illustration.
  18. REMOVE FRONT BUMPER SIDE RETAINER RH 

    HINT: 

    Use the same procedure as for the LH side.

  19. REMOVE NO. 2 FRONT BUMPER ENERGY ABSORBER 
    1. Disengage the 4 guides to remove the No. 2 front bumper energy absorber as shown in the illustration.
      GTY856319Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Remove in this Direction
  20. REMOVE FRONT BUMPER ENERGY ABSORBER 
    1. Disengage the 2 guides to remove the front bumper energy absorber as shown in the illustration.
      GTY868287Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Remove in this Direction
  21. REMOVE FRONT BUMPER REINFORCEMENT 
    1. Remove the headlight assembly LH.

      Refer to PROCEDURE - Step 2

    2. Remove the headlight assembly RH.

      HINT: 

      Use the same procedure as for the LH side.

    3. Disengage the 4 clamps.
      GTY931796Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Remove the 8 bolts and front bumper reinforcement as shown in the illustration.
      GTY902814Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Remove in this Direction
scientia non olet · About LEMON Manuals