LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2019 >> Sequoia SR5, 4WD >> Repair and Diagnosis >> Suspension >> Rear Suspension >> Rear Suspension (Service Information) >> Rear Upper Arm >> Removal [08/2018 - ] >> Procedure

Removal [08/2018 - ]: Procedure

  1. REMOVE FUEL TANK ASSEMBLY 

    (Refer to REMOVAL [08/2015 - ] )

    HINT: 

    Remove the fuel tank before removing the left upper control arm.

  2. REMOVE REAR WHEEL 
  3. REMOVE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH 

    Refer to PROCEDURE - Step 1

  4. SEPARATE REAR DISC BRAKE CYLINDER ASSEMBLY LH 

    Refer to PROCEDURE - Step 4

  5. SEPARATE REAR BRAKE FLEXIBLE HOSE 
    GTY224688Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Remove the 3 bolts and disconnect the rear brake flexible hose.
  6. DISCONNECT REAR SPEED SENSOR WIRE 
    1. Disconnect the rear speed sensor connector.
    2. Remove the 4 bolts and disconnect the rear speed sensor wire.
      GTY610734Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  7. REMOVE REAR UPPER CONTROL ARM ASSEMBLY LH 
    GTY610851Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Remove the 3 bolts and 3 nuts and remove the rear upper control arm.
scientia non olet · About LEMON Manuals