LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2019 >> Sequoia SR5, 4WD >> Repair and Diagnosis >> Suspension >> Rear Suspension >> Rear Suspension (Service Information) >> Rear Shock Absorber >> Removal [08/2018 - ] >> Procedure

Removal [08/2018 - ]: Procedure

  1. REMOVE REAR WHEEL 
  2. REMOVE TAIL EXHAUST PIPE ASSEMBLY 

    Refer to PROCEDURE - Step 1

  3. REMOVE PROPELLER SHAFT ASSEMBLY (for 2WD) 

    (Refer to REMOVAL [08/2015 - ] )

  4. REMOVE PROPELLER SHAFT HEAT INSULATOR (for 4WD) 

    Refer to PROCEDURE - Step 1

  5. REMOVE TRANSFER HEAT INSULATOR (for 4WD) 

    Refer to PROCEDURE - Step 2

  6. REMOVE PROPELLER SHAFT ASSEMBLY (for 4WD) 

    Refer to PROCEDURE - Step 3

  7. REMOVE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY (w/ Air Suspension) 

    Refer to PROCEDURE - Step 1

  8. REMOVE REAR STABILIZER BAR 

    (Refer to REMOVAL [08/2018 - ] )

  9. REMOVE REAR SHOCK ABSORBER ASSEMBLY (w/o Air Suspension) 
    1. Remove the 2 bolts and nut and remove the rear shock absorber.
      GTY309161Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  10. REMOVE REAR SHOCK ABSORBER ASSEMBLY (w/ Air Suspension) 
    GTY310030Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Disconnect the AVS connector.
    2. Remove the 2 bolts and nut and remove the rear shock absorber.
      GTY309161Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals