LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2019 >> Sequoia SR5, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 21 (Starting System (3UR-FBE) (Service Information)) >> Ignition Switch >> Installation [08/2015 - 08/2018] >> Procedure

Installation [08/2015 - 08/2018]: Procedure

WARNING: This page is about a different car, the 2018 Toyota Sequoia, 2017 Toyota Sequoia, and 2016 Toyota Sequoia. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL IGNITION OR STARTER SWITCH ASSEMBLY 
    1. Attach the 2 claws to install the ignition or starter switch assembly.
      GTY611379Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Connect the ignition or starter switch assembly connector.
      GTY541938Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL LOWER STEERING COLUMN COVER 

    Refer to PROCEDURE - Step 13 [08/2015 - 08/2017] , or refer to PROCEDURE - Step 13 [08/2017 - 08/2019]

  3. CUSTOMIZE INFORMATION (for Power Tilt and Power Telescopic Steering Column) 

    Refer to PROCEDURE - Step 23 [08/2015 - 08/2017] , or refer to PROCEDURE - Step 23 [08/2017 - 08/2019]

scientia non olet · About LEMON Manuals