LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2019 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Automatic Transmission (U760E) - Service Information (1 Of 2)) >> Park / Neutral Position Switch >> Removal [12/2013 - ] >> Procedure

Removal [12/2013 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. REMOVE RADIATOR SIDE DEFLECTOR SEAL LH 

    Refer to PROCEDURE - Step 1 , or refer to PROCEDURE - Step 1

  2. REMOVE RADIATOR SIDE SEAL RH 

    Refer to PROCEDURE - Step 2 , or refer to PROCEDURE - Step 2

  3. REMOVE COOL AIR INTAKE DUCT SEAL 

    Refer to PROCEDURE - Step 3 , or refer to PROCEDURE - Step 3

  4. REMOVE INLET AIR CLEANER ASSEMBLY 

    Refer to PROCEDURE - Step 25 , or refer to PROCEDURE - Step 25

  5. REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE 

    Refer to PROCEDURE - Step 3

  6. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 27 , or refer to PROCEDURE - Step 27

  7. REMOVE AIR CLEANER CASE SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 28 , or refer to PROCEDURE - Step 28

  8. SEPARATE TRANSMISSION CONTROL CABLE ASSEMBLY 
    1. Move the shift lever to N.
    2. Disengage the wire harness clamp from the wire harness clamp bracket.
      GTY431161Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Remove the nut from the transmission control shaft lever.
      GTY423470Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Using a screwdriver, disengage the 4 claws, separate the transmission control cable assembly with clip from the No. 1 transmission control cable bracket.
      GTY449978Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    5. Using a screwdriver, disengage the 2 claws and remove the clip from the transmission control cable assembly.
      GTY444212Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  9. REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY 
    1. Disconnect the connector from the park/neutral position switch.
    2. Remove the nut, washer and transmission control shaft lever from the manual valve lever shaft sub-assembly.
      GTY384508Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Remove the 2 bolts and park/neutral position switch assembly from the manual valve lever shaft sub-assembly.
      GTY431168Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      NOTE:

      Before removing the park/neutral position switch assembly, remove any dirt or rust on the installation portion of the transmission control shaft lever. Be sure to remove the park/neutral position switch assembly straight along the transmission control shaft lever while being careful not to deform the plate spring that supports the transmission control shaft lever. If the plate spring is deformed, the park/neutral position switch assembly cannot be reinstalled correctly.

scientia non olet · About LEMON Manuals