LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2017 >> Avalon XLE Plus >> Repair and Diagnosis >> Brakes >> Brakes Control Systems >> Brake Control System (Service Information) (Except Hybrid) >> Skid Control Buzzer >> Removal [10/2014 - 10/2015] >> Procedure

Removal [10/2014 - 10/2015]: Procedure

  1. PRECAUTION 
    NOTE:

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work (Refer to PRECAUTION [10/2014 - ] ).

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
  3. REMOVE LOWER CENTER INSTRUMENT PANEL FINISH PANEL 

    Refer to PROCEDURE - Step 1

  4. REMOVE FRONT DOOR SCUFF PLATE LH 

    Refer to PROCEDURE - Step 4

  5. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH 

    Refer to PROCEDURE - Step 5

  6. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP LH 

    Refer to PROCEDURE - Step 11

  7. REMOVE INSTRUMENT SIDE PANEL LH 

    Refer to PROCEDURE - Step 12

  8. DISCONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 13

  9. REMOVE LOWER NO. 1 INSTRUMENT PANEL SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 14

  10. REMOVE SKID CONTROL BUZZER ASSEMBLY 
    1. Disconnect the connector from the skid control buzzer assembly.
      GTY378889Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
    2. Disengage the clamp to remove the skid control buzzer assembly.
      NOTE:

      Do not use the dropped skid control buzzer assembly.

scientia non olet · About LEMON Manuals