LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2016 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 52 (Audio / Video System (Service Information) (Hybrid)) >> Satellite Radio Tuner >> Installation [02/2014 - ] >> Procedure

Installation [02/2014 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. INSTALL STEREO COMPONENT TUNER ASSEMBLY 
  2. INSTALL NAVIGATION WIRE 
    1. Connect the 3 connectors to install the navigation wire.
  3. INSTALL STEREO COMPONENT TUNER ASSEMBLY WITH WIRE 
    1. Install the stereo component tuner assembly with wire with the 4 screws.
    2. Connect the 3 connectors.
  4. INSTALL RADIO RECEIVER ASSEMBLY WITH BRACKET (for Radio and Display Type) 

    See step  5

  5. INSTALL NAVIGATION RECEIVER ASSEMBLY WITH BRACKET (for Navigation Receiver Type) 

    Refer to PROCEDURE - Step 5

  6. INSTALL NO. 4 INSTRUMENT PANEL REGISTER ASSEMBLY 

    Refer to PROCEDURE - Step 25

  7. INSTALL NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY 

    Refer to PROCEDURE - Step 26

  8. INSTALL CENTER UPPER INSTRUMENT CLUSTER FINISH PANEL 

    Refer to PROCEDURE - Step 27

  9. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL WITH AIR CONDITIONING CONTROL ASSEMBLY 

    Refer to PROCEDURE - Step 28

  10. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL (for Navigation Receiver Type) 
    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Refer to INITIALIZATION [02/2014 - 11/2016] , or refer to INITIALIZATION [11/2016 - ]

  11. INSTALL NO. 3 DECK BOARD SUB-ASSEMBLY (for Navigation Receiver Type) 

    Refer to PROCEDURE - Step 71 , or refer to PROCEDURE - Step 72 , or refer to PROCEDURE - Step 70

  12. INSTALL DECK BOARD ASSEMBLY (for Navigation Receiver Type) 

    Refer to PROCEDURE - Step 72 , or refer to PROCEDURE - Step 73 , or refer to PROCEDURE - Step 71

scientia non olet · About LEMON Manuals