Installation [11/2016 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.

INSTALL HOOD LOCK CONTROL CABLE ASSEMBLY
1. Pass the hood lock control cable assembly into the engine compartment.
2. Pass the cable through the upper radiator support.
3. Engage the hood lock control cable assembly to the 5 clamps and hood cable grommet.

INSTALL HOOD LOCK ASSEMBLY

Apply MP grease to the sliding parts of the lock.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Connect the hood lock control cable assembly.
Install the hood lock assembly with the 2 bolts and hood lock bolt.
Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf)
w/ Engine Hood Courtesy Switch:
1. Connect the connector.

Install a new hood lock nut cap.

INSTALL RADIATOR GRILLE
Refer to INSTALLATION [11/2016 - ]
INSTALL HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
1. Connect the hood lock control cable assembly to install the hood lock control lever sub-assembly.
CONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 33
INSTALL FRONT FENDER LINER LH
HINT:

Use the same procedure as for the RH side.

Refer to PROCEDURE - Step 3
INSTALL FRONT WHEEL OPENING EXTENSION PAD LH
HINT:

Use the same procedure as for the RH side.

Refer to PROCEDURE - Step 4
INSTALL FRONT FENDER WHEEL OPENING MOULDING SUB-ASSEMBLY LH
Refer to INSTALLATION [02/2014 - ]
INSTALL FRONT WHEEL LH
Refer to PROCEDURE - Step 13
ADJUST HOOD SUB-ASSEMBLY
Refer to ADJUSTMENT [11/2016 - ]
INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 34
INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH
Refer to PROCEDURE - Step 54
INSTALL FRONT DOOR SCUFF PLATE LH
Refer to PROCEDURE - Step 55