LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2016 >> Highlander LE Plus, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 109 (Emission Control System (2GR-FXE) - Service Information - (Hybrid)) >> Purge Valve >> Removal [02/2014 - 11/2016] >> Procedure

Removal [02/2014 - 11/2016]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. REMOVE RADIATOR SIDE DEFLECTOR SEAL LH 

    Refer to PROCEDURE - Step 1

  2. REMOVE RADIATOR SIDE SEAL RH 

    Refer to PROCEDURE - Step 2

  3. REMOVE COOL AIR INTAKE DUCT SEAL 

    Refer to PROCEDURE - Step 3

  4. REMOVE INLET NO. 2 AIR CLEANER 

    Refer to PROCEDURE - Step 9

  5. REMOVE V-BANK COVER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 22 , or refer to PROCEDURE - Step 22

  6. REMOVE PURGE VALVE (PURGE VSV) 
    1. Disconnect the purge valve (purge VSV) connector.
      GTY433739Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *1 Fuel Vapor Feed Hose Assembly
      *2 No. 1 Fuel Vapor Feed Hose
    2. Disengage the wire harness clamp.
    3. Disconnect the No. 1 fuel vapor feed hose from the purge valve (purge VSV).
    4. Slide the clip and disconnect the fuel vapor feed hose assembly from the purge valve (purge VSV).
    5. Remove the bolt and purge valve (purge VSV) from the cylinder head sub-assembly.
      GTY307244Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals