Installation [08/2015 - ]: Procedure

1. Install the generator bracket to the generator with the bolt.

   Torque: 20 N*m (204 kgf*cm, 15 ft.*lbf) 

2. Install the generator with the 2 bolts.

   Torque: 43 N*m (438 kgf*cm, 32 ft.*lbf) 

3. Install the generator bracket with the bolt.

   Torque: 20 N*m (204 kgf*cm, 15 ft.*lbf) 

4. Attach the wire harness clamp.
5. Install the wire harness with the 2 bolts.

   Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf) 

6. Connect the generator connector to the generator.
7. Install the generator wire with the nut.

   Torque: 9.8 N*m (100 kgf*cm, 87 in.*lbf) 

8. Close the terminal cap.

Refer to PROCEDURE - Step 3

1. Install the wiring harness clamp bracket with the bolt.

   Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf) 

2. Attach the clamp.

1. For Integrated Type:

   Install the No. 2 idler pulley with the bolt.

   Torque: 54 N*m (551 kgf*cm, 40 ft.*lbf) 

2. For Separate Type:

   Install the idler pulley cover plate, No. 2 idler pulley and No. 2 idler pulley cover plate with the bolt.

   Torque: 54 N*m (551 kgf*cm, 40 ft.*lbf) 

Refer to PROCEDURE - Step 1

Refer to PROCEDURE - Step 14

1. Install the battery clamp with the 2 nuts.

   Torque: 6.0 N*m (61 kgf*cm, 53 in.*lbf)