LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2016 >> 4Runner Limited, AWD >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Mechanical System - Service Information >> Drive Belt >> Installation [08/2015 - ] >> Procedure

Installation [08/2015 - ]: Procedure

  1. INSTALL FAN AND GENERATOR V BELT 
    1. Set the V belt onto every part.
      Fig 1: Engine Drive Belt Routing Diagram
      GTY183426Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      TEXT IN ILLUSTRATION

      Callout Description
      *1 Vane Pump
      *2 Water Pump
      *3 No. 2 Idler
      *4 Generator
      *5 Cooler Compressor
      *6 No. 1 Idler
      *7 Crankshaft
      *8 V-ribbed Belt Tensioner
    2. While turning the belt tensioner counterclockwise, remove the pin.
      NOTE:

      Make sure that the V belt is properly installed to each pulley.

    3. Check that the belt fits properly in the ribbed grooves.

      HINT: 

      Make sure to check by hand that the belt has not slipped out of the grooves on the bottom of the pulley.

scientia non olet · About LEMON Manuals