LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2016 >> 4Runner Limited, AWD >> Repair and Diagnosis >> Body & Frame >> Exterior/Interior Trim >> Exterior Panels / Trim - Service Information >> FRONT BUMPER (w/o Mudguard) >> Removal [08/2021 - ] >> Procedure

Removal [08/2021 - ]: Procedure

  1. REMOVE UPPER RADIATOR SUPPORT SEAL 

    Refer to PROCEDURE - Step 18

  2. REMOVE FRONT BUMPER COVER 
    1. Apply protective tape as shown in the illustration.
      GTY889360Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Protective Tape
    2. Remove the 3 screws.
      GTY924778Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Remove the 4 screws and 2 bolts.
      GTY924777Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Remove the 3 bolts.
      GTY945293Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    5. Remove the 6 clips.
      GTY945292Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    6. Disengage the 7 claws as shown in the illustration.

      HINT: 

      Use the same procedure for the RH side and LH side.

      GTY845001Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Remove in this Direction
    7. Disconnect the 3 connectors.
    8. w/ Panoramic view monitor system:
      1. Disconnect the connector.
    9. Remove the front bumper cover.
  3. REMOVE UPPER CENTER FRONT BUMPER RETAINER 

    Refer to PROCEDURE - Step 11

  4. REMOVE COOL AIR INTAKE DUCT (for 4WD) 
    1. Remove the 4 clips and cool air intake duct.
      GTY442486Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  5. REMOVE FRONT BUMPER LOWER COVER 
    1. Remove the clip.
      GTY437818Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the 4 bolts and front lower bumper cover.
  6. REMOVE AIR INTAKE DUCT LH 
    1. Remove the clip and bolt.
      GTY706113Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the 2 screws and air intake duct LH.
  7. REMOVE AIR INTAKE DUCT RH 

    HINT: 

    Use the same procedure as for the LH side.

  8. REMOVE RADIATOR SIDE DEFLECTOR LH 

    Refer to PROCEDURE - Step 13

  9. REMOVE RADIATOR SIDE DEFLECTOR RH 

    Refer to PROCEDURE - Step 12

  10. REMOVE FRONT BUMPER ENERGY ABSORBER 

    See step  7

  11. REMOVE FRONT BUMPER REINFORCEMENT SUB-ASSEMBLY 
    1. Remove the screw, 6 nuts and front bumper reinforcement sub-assembly.
      GTY437822Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  12. REMOVE NO. 2 FRONT BUMPER EXTENSION SUB-ASSEMBLY LH 

    See step  9

  13. REMOVE NO. 2 FRONT BUMPER EXTENSION SUB-ASSEMBLY RH 

    HINT: 

    Use the same procedure as for the LH side.

  14. REMOVE FRONT BUMPER SIDE SUPPORT LH 

    See step  11

  15. REMOVE FRONT BUMPER SIDE SUPPORT RH 

    HINT: 

    Use the same procedure as for the LH side.

  16. REMOVE FRONT BUMPER BRACKET SUB-ASSEMBLY LH 

    See step  11

  17. REMOVE FRONT BUMPER BRACKET SUB-ASSEMBLY RH 

    HINT: 

    Use the same procedure as for the LH side.

scientia non olet · About LEMON Manuals