Removal (To 12/2010): Removal

NOTE:

Before removing the tire pressure warning ECU, read the registered transmitter IDs of all wheels and write them down to use for re-registration of transmitter IDs. Refer to REGISTRATION .

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
WARNING:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Refer to INITIALIZATION .
REMOVE COWL SIDE TRIM SUB-ASSEMBLY RH . Refer to REMOVAL - Step 21
REMOVE FRONT DOOR SCUFF PLATE RH . Refer to REMOVAL - Step 23
REMOVE INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY NO. 2 . Refer to REMOVAL - Step 29
REMOVE INSTRUMENT PANEL FINISH PANEL LOWER RH . Refer to REMOVAL - Step 30
REMOVE TIRE PRESSURE WARNING ECU
1. Disconnect the connector from the tire pressure warning ECU.
  
  Fig 1: Locating Tire Pressure Warning ECU Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Remove the screw and the tire pressure warning ECU.
  
  Fig 2: Locating Tire Pressure Warning ECU With Screw
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002