Front Passenger Airbag Assembly: Installation

INSTALL INSTRUMENT PANEL WIRE ASSEMBLY
1. Install the clamp.
  
  Fig 1: Identifying Instrument Panel Wire Assembly Clamp
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Connect the 2 airbag connectors.
3. Install the clamp and instrument panel wire assembly on the front passenger airbag assembly.
NOTE: When connecting the airbag connector, take care not to damage the airbag wire harness.

Fig 2: Identifying Instrument Panel Wire Assembly Clamp
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT PASSENGER AIRBAG ASSEMBLY
1. Engage the 5 hooks.
  
  Fig 3: Identifying Front Passenger Airbag Assembly Hooks
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the front passenger airbag assembly with the 5 hooks on the upper instrument panel sub-assembly.
  
  Fig 4: Identifying Front Passenger Airbag Assembly With Hooks
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Install the 2 screws.
INSTALL HEATER TO REGISTER DUCT ASSEMBLY (See REASSEMBLY )
INSTALL UPPER INSTRUMENT PANEL SUB-ASSEMBLY (See INSTALLATION )
CONNECT INSTRUMENT PANEL WIRE ASSEMBLY

Fig 5: Identifying Front Passenger Airbag Assembly Screws
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
1. Check that the ignition switch is off.
2. Check that the cable is disconnected from the negative (-) battery terminal.
  CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
3. Connect the connector.
NOTE: When connecting the airbag connector, take care not to damage the airbag wire harness.
INSTALL NO. 1 INSTRUMENT PANEL BOX DOOR SUB-ASSEMBLY
HINT:

Refer to the procedure from Install No. 1 Instrument Panel Box Door Sub-assembly (See INSTALLATION ).

Fig 6: Locating Instrument Panel Wire Connector
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002