Front Lower Suspension Arm: Installation

INSTALL FRONT LOWER SUSPENSION ARM
1. Install the front lower arm bushing stopper to the front lower suspension arm.
2. Install the front lower suspension arm to the front frame assembly with the 3 bolts and nut, but do not tighten them yet.
  
  Fig 1: Locating Front Lower Suspension Arm Bolts And Nuts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Tighten the 3 bolts in numerical order shown in the illustration.
  Torque: Bolt 1, 2
  
  200 N*m (2039 kgf*cm, 147 ft.*lbf)
  
  Bolt 3
  
  206 N*m (2100 kgf*cm, 152 ft.*lbf)
  
  HINT:
  
  Start installing the bolts from the front side of the vehicle.
  
  Fig 2: Tightening Front Lower Suspension Arm Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT FRAME ASSEMBLY (for 2GR-FE) (See INSTALLATION )
INSTALL FRONT FRAME ASSEMBLY (for 1AR-FE) (See INSTALLATION )
REMOVE ENGINE HANGERS (for 2GR-FE) (See INSTALLATION )
REMOVE ENGINE HANGERS (for 1AR-FE) (See INSTALLATION )
INSTALL POWER STEERING LINK ASSEMBLY (See INSTALLATION )
INSTALL FRONT STABILIZER BAR WITH FRONT STABILIZER LINK ASSEMBLY
INSTALL NO. 1 FRONT STABILIZER BRACKET LH (See INSTALLATION )
INSTALL NO. 1 FRONT STABILIZER BRACKET RH
HINT:

Perform the same procedure as the LH side.
INSTALL ENGINE ASSEMBLY WITH TRANSAXLE
HINT:
- Refer to the procedure from Install Engine Assembly with Transaxle (for 2GR-FE) (See INSTALLATION ).
- Refer to the procedure from Install Engine Assembly with Transaxle (for 1AR-FE) (See INSTALLATION ).