FRONT STABILIZER BAR (for 2GR-FE): Installation

1. Install the 2 No. 1 front stabilizer bar bushings to the front stabilizer bar as shown in the illustration.
   NOTE: Install the No. 1 front stabilizer bar bushings so that the cutout faces the rear of the vehicle.

Fig 1: Installing No. 1 Front Stabilizer Bar Bushings To Front Stabilizer Bar

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Install the No. 2 front stabilizer bracket LH to the No. 1 front stabilizer bar bushing.

HINT:

Perform the same procedure as the LH side.

1. Install the front stabilizer bar by inserting it from the right side of the vehicle.

Fig 2: Identifying No. 2 Front Stabilizer Bracket

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Install the No. 1 front stabilizer bracket LH to the front frame assembly with the 2 bolts.

   Torque: 29 N*m (296 kgf*cm, 21 ft.*lbf) 

HINT:

Perform the same procedure as the LH side.

Fig 3: Locating No. 1 Front Stabilizer Bracket RH

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Install the front stabilizer link assembly LH with the nut.

   Torque: 74 N*m (755 kgf*cm, 55 ft.*lbf) 

   HINT:

   If the ball joint turns together with the nut, use a hexagon wrench (6 mm) to hold the stud bolt.

HINT:

Perform the same procedure as the LH side.

Fig 4: Separating Front Stabilizer Link Assembly LH

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

HINT:

Install engine assembly with transaxle (See INSTALLATION ).

HINT:

Inspect and adjust front wheel alignment (See FRONT WHEEL ALIGNMENT ).