LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2009 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (Transfer Case -MF2A) >> Bearing Retainer Oil Seal >> Removal

Bearing Retainer Oil Seal: Removal

WARNING: This page is about a different variant/trim than selected.
  1. DRAIN AUTOMATIC TRANSAXLE FLUID  (See REMOVAL )
  2. REMOVE NO. 1 TRANSFER CASE PLUG  (See DISASSEMBLY )
  3. REMOVE TRANSFER DRAIN PLUG  (See DISASSEMBLY )
  4. REMOVE ENGINE UNDER COVER ASSEMBLY 
  5. REMOVE NO. 1 ENGINE UNDER COVER 
  6. REMOVE NO. 2 ENGINE UNDER COVER 
  7. DRAIN AUTOMATIC TRANSAXLE FLUID  (See REMOVAL )
  8. REMOVE FRONT WHEEL 
  9. REMOVE FRONT AXLE HUB NUT  (See REMOVAL )
  10. SEPARATE FRONT STABILIZER LINK ASSEMBLY  (See REMOVAL )
  11. SEPARATE FRONT SPEED SENSOR  (See REMOVAL )
  12. SEPARATE TIE ROD END SUB-ASSEMBLY  (See REMOVAL )
  13. SEPARATE NO. 1 FRONT SUSPENSION LOWER ARM  (See REMOVAL )
  14. SECURE FRONT AXLE HUB SUB-ASSEMBLY  (See REMOVAL )
  15. REMOVE FRONT DRIVE SHAFT ASSEMBLY RH (for 2WD)  (See DISASSEMBLY )
  16. REMOVE FRONT DRIVE SHAFT ASSEMBLY RH (for 4WD)  (See DISASSEMBLY )
  17. FRONT DRIVE SHAFT HOLE SNAP RING  (See DISASSEMBLY )
  18. REMOVE TRANSFER RH BEARING RETAINER OIL SEAL 
    1. Using SST, remove the transfer RH bearing retainer oil seal.

      SST 09308-00010 

    NOTE: Do not damage the oil-seal-fitted surface of the case.
    Fig 1: Removing Transfer RH Bearing Retainer Oil Seal
    G05241001Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals