Ignition Switch: Installation

WARNING: This page is about a different variant/trim than selected.

INSTALL IGNITION SWITCH ASSEMBLY
1. Engage the 2 claws to install the ignition switch.
  
  Fig 1: Locating Ignition Switch Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Connect the ignition switch connector.
INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY (See INSTALLATION )
INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH (See INSTALLATION )
INSTALL FRONT DOOR SCUFF PLATE LH (See INSTALLATION )

Fig 2: Locating Ignition Switch Connector
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL STEERING COLUMN COVER LOWER
1. Engage the 2 claws to install the steering column cover lower.
  
  Fig 3: Identifying Steering Column Cover Lower Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Insert the key into the ignition key cylinder and release the steering lock.
3. Turn the steering wheel counterclockwise and install the screw.
  
  Fig 4: Locating Steering Column Cover Lower Screw
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Turn the steering wheel clockwise and install the screw.
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).

Fig 5: Locating Steering Column Cover Lower Screw