REAR SPEED SENSOR (for 2WD): Installation

HINT:

If the sensor rotor needs to be replaced, replace it together with the rear axle hub and bearing assembly with rear speed sensor.

INSTALL REAR SPEED SENSOR
1. Clean the contact surface between the rear axle hub and bearing assembly and a new rear speed sensor.
  NOTE: Prevent foreign matter from attaching to the sensor rotor.
2. Place the rear speed sensor on the axle hub so that the connector is positioned as shown in the illustration.
  
  Fig 1: Identifying Rear Speed Sensor Installation Position On Axle Hub
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Using SST, a steel plates, V-blocks and press, install a new rear speed sensor to the rear axle hub and bearing assembly.
  SST 09214-76011, 09213-58013
NOTE:
- Keep the rear speed sensor away from magnets.
- Do not use a hammer to install the rear speed sensor.
- Check that there is no foreign matter such as iron chips on the detecting portion of the rear speed sensor.
- Slowly press the rear speed sensor in straight.
Fig 2: Installing Rear Speed Sensor To Rear Axle Hub And Bearing Assembly
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL REAR AXLE HUB AND BEARING ASSEMBLY WITH REAR SPEED SENSOR (See INSTALLATION )
INSPECT REAR AXLE HUB BEARING LOOSENESS (See ON-VEHICLE INSPECTION )
INSPECT REAR AXLE HUB RUNOUT (See ON-VEHICLE INSPECTION )
INSTALL REAR DISC (See REASSEMBLY )
INSTALL REAR DISC BRAKE CALIPER ASSEMBLY (See REPLACEMENT )
INSTALL REAR SPEED SENSOR WIRE
1. Connect the connector to the rear speed sensor.
INSTALL REAR WHEEL
Torque: 103 N*m (1050 kgf*cm, 76 ft.*lbf)
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected. (See INITIALIZATION )

Fig 3: Connecting Rear Speed Sensor Connector
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSPECT AND ADJUST REAR WHEEL ALIGNMENT
HINT:

(See REAR WHEEL ALIGNMENT )
CHECK FOR SPEED SENSOR SIGNAL
HINT:

(See TEST MODE PROCEDURE )