Tire Pressure Warning Ecu: Installation

INSTALL TIRE PRESSURE WARNING ECU
1. Connect the connector to the tire pressure warning ECU.
  
  Fig 1: Locating Tire Pressure Warning ECU Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the tire pressure warning ECU with the nut.
  Torque: 8.5 N*m (87 kgf*cm, 75 in.*lbf)
INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY (See INSTALLATION )
INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (See INSTALLATION )
INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH (See INSTALLATION )
INSTALL FRONT DOOR SCUFF PLATE RH (See INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Fig 2: Identifying Tire Pressure Warning ECU Connector Nut
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).
REGISTER TRANSMITTER ID
HINT:

See REGISTRATION .
INSPECT TIRE PRESSURE WARNING SYSTEM
HINT:

See TEST MODE PROCEDURE .
INITIALIZE SYSTEM

NOTE:

Be sure to register the transmitter IDs of all tires in the ECU before initialization.
Be sure to inflate all tires to the proper inflation pressure before initialization.

HINT:

See INITIALIZATION .