Stop Light Switch: Installation

INSTALL STOP LIGHT SWITCH ASSEMBLY
1. Temporarily install the stop light switch assembly with the stop light switch lock nut.
  
  Fig 1: Installing Stop Light Switch Assembly With Lock Nut
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Turn the stop light switch assembly so that the clearance between the nut end and stop light switch cushion is between 0.5 to 2.4 mm (0.020 to 0.095 in.).
3. Tighten the stop light switch lock nut.
  Torque: 17 N*m (173 kgf*cm, 12 ft.*lbf)
  
  Fig 2: Identifying Clearance Between Nut End And Stop Light Switch Cushion
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Connect the connector.
INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY (for Manual Air Conditioning System) (See INSTALLATION )
INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY (for Automatic Air Conditioning System) (See INSTALLATION )
INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH (See INSTALLATION )

Fig 3: Locating Stop Light Switch Assembly Connector
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT DOOR SCUFF PLATE LH (See INSTALLATION )